FIELDMARSHAL FM10DI, 10HP Diesel Engine
- FM10DI, 10 HP Slow Speed Diesel Engine
- FM10DI, Slow Speed Diesel Engine
- Single Cylinder, 1000 RPM, ISI Model
- TRB Type
- Bore 120 mm, B1 Class Governing.
- FM10DI, 10HP, 1000 RPM, Single Cylinder Slow Speed Diesel Engine.
Application
- Irrigation
- Pumping Set
- Thresher
- Power Generation
- Rice Mill
- Sugarcane Crusher
- Turbine Pump
- Oil Expeller
- Stone crusher
- Concrete mixture
- Conveyor belt drive
- Vertical Diesel Engine is rated on the effective Horse Power at engine crankshaft as a maximum load for continuous running. Each engine is tested as per IS 1001 - 1981 to give a continuous rating.
- COOLING: Engine cooling is efficiently handled by a run-through water supply. A Radiator or a Cooling Tank can also be provided if required.
- LUBRICATION: All internal moving parts are lubricated by a splash system. In case of bush bearing type, 8 HP B/W, 10 HP and above 10 HP Engines, lubrication is by plunger type lubricating pump which is mounted below fuel pump bracket and provides lubricating oil to Taper Roller Bearings & Connecting Rod, big end bearing through Banjo Oil Ring mounted on the crankshaft. Parts like Valves, Push Rods, etc. could be lubricated with Oil Can.
- ROTATION: Standard rotation is clockwise, facing the flywheel, keeping the exhaust on the left-hand side.
- FUEL INJECTION EQUIPMENT: MICO (BOSCH) or USHA Fuel Injection Equipment or equivalent.
- GOVERNING: A sensitive centrifugal type Governor is mounted on a camshaft gear wheel. Speed Variation is controlled within the limit to comply with "B1" Class Governing as mentioned in IS 10000 (Part - 7) 1980.
- CYLINDER LINER: The Cylinder Liner is Hard Chrome Plated and has an exceptionally long life.
- AIR CLEANER: Oil Bath Type Air Cleaner is provided to clean the incoming air. The use of clean air increases the life of the Cylinder Liner.
- STANDARD EQUIPMENT: Pulley, Spanner Set, Screw Driver, Oiler tool, Starting Handle, Air Cleaner, Silencer, Fuel Tank, Tool Bag Instruction Manual, and Hose Nipple.
- IMPORTANT NOTE: TO GET MORE EFFICIENT ENGINE PERFORMANCE, THE TEMPERATURE OF COOLING WATER COMING OUT FROM THE ENGINE HEAD SHOULD BE IN BETWEEN 50°C TO 70°C. KINDLY OPERATE THE ENGINE AT THIS TEMPERATURE ONLY.
MODEL FM 10 DI
BORE (m.m.) - 120
STROKE (m.m.) - 139.7
DISPLACEMENT (cm³) -1580
No. OF CYLINDER - ONE
COMPRESSION RATIO - 17.1
RATED R.P.M. - 1000
INJECTION METHOD - DI
SPECIFIC FUEL CONSUMPTION (g/kWh) - 240
POWER (H.P./kW) - 10 / 7.35
MAX. TORQUE Nm@RPM - 70.18 @ 1000
METHOD OF STARTING - HANDLE START
ENGINE COOLING METHOD - WATER COOLED
OIL SUMP CAPACITY (Liters) - 4.5
GRADE OF OIL SAE - 30/40
ENGINE DIMENSION - LENGTH (m.m.) 914.4, WIDTH (m.m.) 590, HEIGTH (m.m.) 990
ENGINE NET WEIGHT (kg.) DRY - 325
