Some of your Questions:

Q. Is FM BRAND submersible pump good or bad?

FM Pump is Very Goog Quality & After Problem Service is also Very good. Fully Satisfied. Always buy any FM Pump Again..

Q. What is the common problem of submersible pumps?

Overloading is a frequent cause of submersible pump failures. It happens when the pump is exposed to operating circumstances that exceed its specified capacity. Operating the pump beyond its limitations might place undue strain on the motor and impellers, leading to premature wear and possible failure.

Q. What is the life of a submersible pump?

The life expectancy of the submersible pump depends on different factors, such as quality, electrical supply/voltage of the pump, and for how many hours it will be used. On average, for a residential 3-wire submersible pump, the shelf-life is 5-6 years, and for a 2-wire pump, it's 6-7 years.

Q. How do I know if my submersible pump is good?

The flow rate, often known as the discharge rate, is measured in liters per minute (LPM). This is the quantity of water pumped in a certain length of time. The faster it pumps, the higher it is. A home normally requires between 100 and 200 LPM

Q. How do you protect a submersible pump?

Setting the motor protection on a submersible pump Set over current release to the stamped maximum motor current. Let the pump run for half an hour at normal power. Set the overcurrent release successively lower until the trip point is reached. After that, set the over current release 5% above this trip point.

Q. What causes submersible pump to overheat?

Inadequate Voltage In most cases, the spike causes an excess electrical current that the motor and pump can't handle, which results in overheating, and usually a pump failure. If you can avoid using your pump during storms, you should—otherwise you could invest in a quality surge protector.

Q. How many hours can a submersible pump run continuously?

Submersible pumps can run from 6 to 24 hours continuously depending upon the quality and efficiency of your pump.

Q. Which type of pumps are used for Borewell?

A Submersible Pump is a device with a sealed motor which is completely submerged in water bodies, especially open wells and bore wells. They are an efficient and wiser choice since they do not require any priming as they are already submerged into water.

Q. How do I choose a pump flow rate?

Calculating the desired flow rate of your pump is quite easy. Let's say, you want to transport 300 litres of a fluid every 30 minutes, then your pump system has to transport 300/30 = 10 litres per minute or 0.167 litres per second. This is the desired flow rate, which is usually calculated before the installation.